Pro-Form LX 360 Manuel d'utilisateur télécharger pdf (Page 5)

ASSEMBLY

Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not

dispose of the packing materials until assembly is completed.

Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a

small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal

condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off

the lubricant with a soft cloth and a mild, non-abrasive cleaner.

Assembly requires the included allen wrenches and your own phillips screwdriver ,

9/16” wrench , wire cutters , and needlenose pliers .

To identify small parts during assembly, use the PART IDENTIFICATION CHART in the center of this manual.

1. Make sure that the power cord is unplugged.

With the help of a second person, carefully tip the

treadmill onto its left side as shown. Partially fold the

Frame (86) so that the treadmill is more stable.

Do not

fully fold the treadmill until it is completely assem-

bled.

Attach four Base Pads (57) to the bottom of the Base

(69) with four 1” Tek Screws (58) (three are shown).

2. Hold one of the Uprights (73) near the Base (69), with

the holes on the indicated side. Straighten the Wire

Harness (42), and feed it into the lower end of the Upright

and out of the large hole near the upper end.

Insert two 2 1/2” Bolts (37) with 3/8” Star Washers (38)

into the bottom of the Base (69) and the lower end of the

Upright (73);

be careful not to damage the Wire

Harness (42). Firmly tighten an Upright Nut (109) onto

each Upright Bolt.

Attach the other Upright (not shown) as described

above. Note: There is not a wire harness on the left side.

Refer to the inset drawing. Clip two U-nuts (108) over

the two round holes in each of the Uprights (73) as

shown. Press an Upright Endcap (107) onto the top of

each Upright. Note: Make sure the angle of the ends of

the Endcap matches the angle of the Upright.

Holes

109

108

107

1 2 3 4 5 6 7 8 9 10 ... 18 19

Pas de commentaire

Pro-Form LX 360 Manuel d'utilisateur Page 5